5.3.4. - Selecting the Hardware Configuration
The final step in the initial spec installation
is to set the hardware configuration
specific to your site.
You can either do that by starting the spec program and typing
config, which is macro that executes the configuration editor,
or you can run the configuration editor directly.
For the latter, first change to
/usr/local/lib/spec.d
(or to
the auxiliary file directory
specified
when you did the installation).
If you are installing the normal four-circle version of the
program, type the command
edconf fourc.
If you installed a different geometry,
give the name of that geometry as the argument.
This command starts a
spread-sheet styled
program that lets you select motor parameters,
devices names,
CAMAC slot
assignments, etc.
Refer to the notes on the configuration editor that
follow for instructions on using
edconf.
|
Prev | Next 